¶ 1. Prepare the filaments
Please unbox two filament spools according to the G-code file you downloaded (or the G-code file you chose from the SD card), and put them on the filament holder. ↓
¶ 1.1 Graphic guidance
To make it easier to load the filament through the two long tubes, we suggest you sharpen and straighten the ends of the filaments.
 |
 |
 |
 |
¶ 1.2 Video guidance
This is a video showing you how to sharp the filaments: ↓
¶ 2. Take off the filament loading tubes
¶ 2.1 Graphic guidance
Before inserting the filaments into the extruders, you need to pull the two filament loading tubes out first.
 |
 |
¶ 2.2 Video guidance
This is a video showing you the method: ↓
¶ 3. Load the filaments through the sensors
Load the filament through the two sensors:
Straighten and sharpen the two ends of the filaments
Insert the filaments through the filament guide tubes
¶ 4. Load the filaments through the extruders
¶ 4.1 Graphic guidance
 |
 |
 |
 |
¶ 4.2 Video guidance
This is a video showing you how to load the filaments through the extruders: ↓
¶ 5. Tighten the filaments
To avoid filament twining and lead to print failure, please tight the filament spool before printing. ↓
 |
Follow the video to tighten the filaments |
¶ * Supply BOX
If you are using a supply box, please load the filaments from the supply box. ↓
 |