¶ 1. Pause Printing
When you notice the filament is running out, please press the knob and choose "Pause Print".
¶ 2. Pull out the remaining filament
⚠️ Please do this after the print head withdraws the filament from the hot-end.
Then load a new filament spool on the spool holder.
¶ 3. Load new filament
⚠️: Please insert the filament into the hot-end
# 4\. Heat the nozzle again
 |
 |
¶ 5. Purge more
Choose "Purge more" to clean and fill the hot-end.
The print head will extrude filament from the nozzle.
⚠️: Please observe whether there is melted filament coming out of the nozzle.
 |
 |
¶ 6. Continue
⚠️: Do this step only when you see melted filament coming out of the nozzle.
Select the "Continue" menu, then press the knob to resume 3D printing.
