When the filament runs out, the printer will pause printing automatically, and pop up a reminder on the screen:
⚠️ Please make sure you have turned on the "Runout Sensor" in the firmware.
¶ 1. Pull out the used filament from the extruder
Then load a new filament spool on the spool holder.
¶ 2. Load the new filament into the extruder
⚠️: Please insert the filament into the hot-end
¶ 3. Heat the nozzle again
 |
 |
¶ 4. Purge more
Choose "Purge more" to clean and fill the hot-end.
The print head will extrude filament from the nozzle.
⚠️: Please observe whether there is melted filament coming out of the nozzle.
 |
 |
¶ 5. Continue
⚠️: Do this step only when you see melted filament coming out of the nozzle.
Select the "Continue" menu, then press the knob to resume 3D printing.
