¶
Safety Instruction
¶
Unpacking and Installation
¶
Unpacking
¶
Check the items
¶
Check the exterior
¶
Install the spool holder
¶
Function test
¶
Important Matters
¶
Name of Parts
¶
First Layer Quality
¶
Keep the Filament Dry
¶
Replacement reminder
¶
Size deviation
¶
Tools you should buy
¶
Preparation
¶
Spray Adhesion
¶
Z-offset
¶
Skip Leveling
¶
Quick Print Test
¶
Choose the test file
¶
Load-Filaments
¶
Select to print
¶
Useful Tips
¶
PTFE Tube Reminder and Clear Method
¶
Replace the filament spool once it runs out
¶
Replace the filament before it runs out
¶
Clean the extruders
¶
Remove large flat prints without damaging the glass plate
¶
After 3D Printing
¶
Unload/Replace the filament
¶
Store the Filament
¶
Clean the build plate
¶
Software
¶
Download & Installation
¶
Registration
¶
Design and Slice
¶
3D Printing Filaments
¶
SoliFuse Filament Introduction
¶
Tips and Tricks
¶
Store and Dry the Filament
¶
Change Filament
¶
Filament Running Out
¶
Manual Intervention
¶
Maintence
¶
Clean
¶
Lubrication
¶
Inspect the wearing parts
¶
Faults and Solutions
¶
No extrusion
¶
Stringing
¶
Warping
¶
Layer shift
¶
Bad first layer quality
¶
Firmware error alerts
¶
Four-corner leveling compensation test (X2)
¶
Four-corner leveling compensation test (X3)
¶
Fix the EEPROM (settings loss)
¶
Probe Failed Troubleshooting
¶
Probe Fault Test Function
¶
Filament Runout Sensor Test Function
¶
Replacement Guide
¶
Replace the nozzle
¶
Unclog the hot-end
¶
Replace the leveling sensor
¶
Replace the leveling sensor probe
¶
Replace the hot-end module
¶
Replace the extruder
¶
Replace the short PTFE tubes
¶
Replace the “Y” filament loading module
¶
Replace the PTFE conical filament guide part inside hot-end
¶
Replace the air flue
¶
Replace the New-Version drive board
¶
Firmware & 3D Printed Parts
¶
Firmware Updates
¶
3D Printed Parts